- Overview
- Specs
1/0 gauge complete power, ground and signal installation kit for two amplifiers.
17 feet of 1/0 AWG power wire
3 feet of 1/0 AWG ground wire
4 feet of 4 AWG power wire
4 feet of 4 AWG ground wire
ANL/MAXI fuse holder and fuse
30 feet of 16 AWG speaker wire
(3) 16 feet twisted pair RCAs
(2) 4 AWG distribution block
20 feet of remote wire
300 Amp fuse
FEATURES AT A GLANCE
- 1/0 AWG (53.5mm²) 4,704 strands
- 16 AWG (1.31mm²) 65 strands
- 4 AWG (21.1mm²) 1,862 strands
- Includes appropriate wire termination hardware
- FULL spec cable - meets or exceeds AWG (American Wire Gauge) requirements
- 100% Pure Crystal-Oxygen Free Copper (PC-OFC)
- 1 Year Warranty
Fuse Type ANL
Battery PWR/GND Gauge 1/0 AWG
Amplifier PWR/GND Gauge 4 AWG
Speaker Wire Gauge 16 AWG
Fuse Size 300 Amp
Dual Amp Installation Kit Yes
CTA-2015 |
Rockford Fosgate cables conform to the CTA-2015 industry standard. The standard specifies the exact amount of copper needed to indicate a specific wire diameter or gauge size (8 AWG, 4 AWG, etc). Some manufacturers substitute thicker insulation for copper. With Rockford Fosgate, you get exactly what you pay for. |
Includes Power Wire |
This amplifier kit includes power wire by including necessary cable for both B(+) and GND(-) connections. Additionally, amplifier kits include remote turn-on power wire. All cables in this kit conform to the CEA-2015 AWG specification. |
Includes Fused Dist. |
This amplifier kit includes fused distribution. It utilizes a stand-alone fuse holder that can be installed in a convenient place under the hood. |
Dual Amp Installation |
This amplifier kit is designed to install two amps in one system. This includes all necessary cables for proper connection; power, ground, turn-on and RCA signal. All cables in this kit conform to the CEA-2015 AWG specification. |
Includes Speaker Wire |
This amplifier kit includes speaker wire. These cables connect the amplifier to the speakers. All wires in this kit conform to the CEA-2015 AWG specification. |
Includes RCA Cables |
This amplifier kit includes RCA patch cables. These are the necessary cables used to transfer low-level signal from the source unit to the amplifier, typically located in the rear of the vehicle. |